Does this bumper have fog light cutouts or will I need to cut them?

Verify your vehicle's OEM fog light opening size and location before installation. The 1M look design accommodates factory fog lamp housings, but you'll need to confirm cutout alignment matches your bumper beam and headlight assembly setup. Measure and test-fit the cover before committing to any modifications.

Will this work with my bumper sensors, or do I need to relocate them?

Reference your vehicle's original sensor hole locations on the OEM bumper before installing this cover. If your factory sensors sit in the lower valance or center section, you may need to drill corresponding holes in this panel to maintain sensor function. Check sensor depth and mounting orientation against the new fascia geometry.

What prep work does this need before paint?

Sand the entire surface with appropriate grit to establish adhesion for your primer and topcoat system. Inspect for any voids or imperfections in the gelcoat and fill as needed. After sanding, wipe clean and allow the surface to dry fully before applying your chosen primer and paint finish.