Overview: 

PM06D provides regulated power supply for your Pixhawk® 5X & 6X from the battery, as well as current consumption and battery voltage measurements, all through a 6pin cable. It has built-in power distribution, allowing you power your ESC and FC with the same board.

The on-board switching regulator outputs 5.2V and a maximum of 3A from LiPo batteries up to 14S. The Power Module comes completely assembled with a XT60 connector and a capacitor. The Molex 2.00mm pitch CLIK-Mate Wire-to-Board connector is rated for 3.0A current per contact.

Please Note:

• - PM06D is supported by PX4. For Ardupilot, it is supported in version 4.4 and later. 
• - This PM uses I2C digital signal data output and is not compatible with flight controller that uses analog PM such as the Pixhawk 6C & Mini, Pixhawk4 & Mini, pix32 v5, or Durandal flight controllers

Specifications:

• • Input voltage: 2~14S 
• •  PCB Cont. Current Rating: 70A
• •  PCB Burst Current Rating: 120A (<60 Sec)
• • Max current sensing: 327A
• • Voltage and current monitor with I2C compatible interface
• •  Connector Outputs: 5.2V and 3A max 
• • Weight: 24.5g

Current Rating:

The PM06D comes with XT60 plugs with 14 AWG silicone wires rated for 30A continuous current and 60A burst current (<1 minute). If a higher current is needed, the plug type and wire size should be changed accordingly. You can refer to this chart as reference.

Package Includes：

• - 1x PM06 board
• - 1x  6pin 2.00mm pitch cable