AndCoat WD Thixo – Water-Based Epoxy Coating for Floors and Walls

AndCoat WD Thixo is a water-dispersed, solvent-free epoxy resin coating designed for use on floors and walls in environments where durability, hygiene, and chemical resistance are essential. Suitable for garages, warehouses, workshops, car parks, and even prison cells, it forms a tough, satin-gloss finish that withstands light vehicular traffic, oils, and solvents. Its low-odour, solvent-free formulation makes it ideal for use in food and beverage production areas and other sensitive environments.

Key Features:

• Water-dispersed, solvent-free epoxy formulation
• Tough, durable, and easy to clean
• Excellent abrasion and chemical resistance
• Suitable for concrete and steel substrates
• Hygienic satin gloss finish – ideal for food-grade environments
• Low odour – suitable for confined or occupied spaces
• Can be used for lining concrete and steel tanks
• Available in standard colours (special colours on request)

Surface Preparation

To be assured of maximum adhesion and best properties from our products the correct surface preparation is essential. The concrete substrate must be a minimum of 28 days old and the residual moisture content must be a maximum of 75% RH. The substrate should be sound with a minimum compressive strength of 25 N/mm2 and a minimum pull-off strength of 1.5 N/mm2. The surface must be clean, dry and free of contaminants such as dirt, oil, grease, coatings and surface treatments and contain a functioning damp proof membrane. If in doubt, apply a test area first. Concrete substrates should be mechanically prepared using vacuum enclosed abrasive blast cleaning or diamond grinding equipment to remove laitance and previous surface treatments followed by thorough vacuuming leaving an open textured surface. Weak concrete must be removed and repaired using
recommended our products.

Technical Data

• Coverage: Approx. 7 m² per kg per coat
• Film Thickness: Approx. 150µm DFT per coat
• Recoatable: After 24 hours
• Traffic Ready: Pedestrian and light vehicle traffic after 24 hours

Directions for Use

This product is supplied ready for use. No additions should be made. Pour all of the contents of the part A container into the part B container and thoroughly mix using a slow
speed mixing drill and paddle, avoiding air entrainment. Mix for a minimum of 5 minutes until the material forms a uniform colour and consistency. Scrape down the sides a er
2 minutes to ensure that all materials are fully incorporated. 

Never mix by hand. Do not split packs.

Apply by brush or roller onto the prepared surface at a nominal rate of 0.125 to 0.165 kg/m2 per coat, equivalent to a dry film thickness of 60 to 100 microns. A minimum two coat application is recommended, with subsequent coats a er a minimum interval of eighteen-hours curing. Ensure good ventilation a er application, as this speeds up the physical drying stage of the curing process. The ambient temperature and relative humidity of the works area should be a minimum of 15°C and <65%RH during the application and curing period, if not adhered to this can affect the colour, appearance and performance of the system. Materials and substrate temperature must be above 10°C at
all times.

Data Sheets

AndCoat WD Thixo TDS

AndCoat WD Thixo Part A MSDS

AndCoat WD Thixo Part B MSDS