NEW STOCK IN !!!

These are an easy to fit answer to saggy spongy rear suspension and the feeling you are driving a Jelly.

Unlike many other solutions out there, this does not require modification to the suspension, additional brackets or expertise, They are cheaper too and you get new shock absorbers built in as a bonus.

If you can change shock absorbers you can fit these. just two nuts to carefully undo and take off the old shock absorbers, then fit the matching new bushes to the new and fit them and refit the nuts to the correct factory torque.

You will need a jack and axle stands to raise and support the chassis leg while you use the jack to raise and lower the axle, do one side at a time.

The tension of the spring is adjustable via the supplied spanner as is the damping via applying nitrogen to the valve, we do not recommend doing this unless you are competent with high pressure nitrogen however and we cannot warrant damage caused from this action etc..

NOTE: we strongly advise you use a good penetrating oil or heat on the truck shock absorber retaining nuts if they have not been undone for sometime, a cordless impact driver on low setting helps too gradually loosen them.  Do NOT force with a long socket bar or high impact setting, you risk snapping the stud off.