• Free of hydrocarbon solvents: eco-friendly treatment
• Being a water-based product, it withstands residual humidity conditions and can therefore be applied 24–48 hours after the initial wash, thus speeding up the treatment
• Single-coat application: apply the product and rub it gently over the surface until it is completely absorbed • Does not form surface film and does not yellow
• Ideal for protecting tables, as well as kitchen and bathroom tops
• The surface can be walked on after just 2 hours
• A product with an extremely low VOC and a low environmental impact; it also has the INDOOR AIR COMFORT GOLD certificate

HOW TO USE IT:

No dilution required: ready to use.

Application: Shake before use. For materials with matt finish (natural stone, terracotta, agglomerates, concrete tiles): Apply MP90 ECO XTREME evenly and continuously on a clean and dry surface using a brush or fleece pad, wetting the grout lines as well. Dab any excess product with a clean cloth before it dries. On highly absorbent materials, apply two coats of product with a 20-minute interval in between.

For polished porcelain tiles, natural stone, agglomerates with glossy finish: Apply MP90 ECO XTREME on a clean and dry surface, wetting the material and grout lines completely using a brush or fleece pad. Before the product dries (roughly 10-15 minutes), rub it using a microfibre cloth wetted with the product to favour its penetration. Dry the surface with a clean cloth. To speed up the process, it is possible to treat the surface with a single-disc floor scrubber.

To complete the cycle with the finish: On porous materials such as natural stone, reconstructed tiles, agglomerates and concrete tiles laid in indoor environments, a finishing wax can be applied depending on the material and on the desired effect (MATT, SATIN, CLASSIC, LONGLIFE). The surface can be walked on after just 2 hours. Water- and oil-repellent protection takes effect after 24 hours.

Maintenance: use a diluted solution of CLEANER PRO.