If you’re diving into a gear swap on your Ford with an 8.8” rear end, the Yukon Pinion Installation Kit is a solid choice, especially if your ride isn’t too far gone. This kit is designed for those of us who want to keep reusing our carrier bearings and races—no need to toss everything out just because you’re upgrading your gears. Inside, you’ll find Timken bearings and races, which are known for their durability, plus all the seals and little bits you’ll need to get the job done right.

What’s in the box? You’re getting:

• Pinion bearings and races
• A pinion seal to keep everything nice and tight
• A crush sleeve
• A complete shim kit for fine-tuning
• Marking compound with a brush, because you’ll want to check your setup

This kit isn’t just thrown together; Yukon really does their homework. They make sure you’ve got everything you need for a proper install. Plus, the tapered bearing type ensures a snug fit, which is crucial for performance and longevity.

Now, let’s talk fitment. This kit is compatible with a bunch of Ford models, so if you’ve got one of these, you’re in luck:

• Ford Bronco (1983-1996)
• Ford Crown Victoria (1992-2011)
• Ford F-150 (1983-2022)
• Ford Mustang (1979-2014)
• Lincoln Navigator (1998-2014)
• And quite a few more!

Keep in mind, this kit is tailored for Ford’s 8.8” rear end, which means it’s not going to fit everything out there. But if you’re in the sweet spot of compatibility, you’re golden.

So, if you’re ready to take on that gear install, grab the Yukon Pinion Installation Kit. It’ll save you a headache and keep your ride running smooth.