Coo-Var Swimming Pool Paint is a high-performance chlorinated rubber coating designed for protecting and redecorating concrete swimming pools.

Formulated to provide excellent resistance against pool chemicals, UV exposure and constant water immersion, this specialist coating leaves a durable gloss finish that keeps pools looking clean, bright and professionally maintained.

Suitable for both newly constructed and previously painted chlorinated rubber pools, the coating is ideal for commercial pools, leisure centres, hotels, schools and domestic swimming pools.

Its smooth, easy-clean finish resists staining and algae build-up while helping extend the life of concrete pool structures.

Pair with Coo-Var Acid Etch for maximum adhesion

✔️ Durable chlorinated rubber formulation
✔️ Excellent water and chemical resistance
✔️ UV resistant gloss finish
✔️ Suitable for new and refurbished pools
✔️ Easy to clean surface
✔️ Available in white and blue shades
✔️ Ideal for commercial and domestic pools

Surface Preparation

Proper preparation is essential for long-term adhesion and performance.

New Concrete Pools:

• Allow concrete to cure for a minimum of 28 days
• Moisture content must be below 7% before coating
• Remove laitance, dirt and contaminants using pressure washing
• Treat surface using Coo-Var Acid Etch diluted 3:1 with water
• Rinse thoroughly and allow to dry completely

Previously Painted Pools:

• Ensure existing coating is compatible
• Remove loose or failing coatings mechanically
• Degrease thoroughly and abrade surface with 120 grit paper
• Clean away dust before application
• Always test compatibility on a small area first

Important:

Do not apply to damp surfaces or if rain is expected before curing.

Technical Data

Directions for Use

Before application, ensure the pool surface is fully prepared, clean and completely dry. New concrete should be allowed to cure for a minimum of 28 days and moisture content must be below 7% before painting.

For concrete swimming pools, thoroughly clean the surface using a suitable degreaser and prepare using an acid etch solution to remove laitance and create a strong key for adhesion. Bare concrete should then be primed using a thinned coat of Coo-Var Swimming Pool Paint diluted by approximately 10–15% with Swimming Pool Paint Thinners.

Previously painted plaster or rendered surfaces should be cleaned thoroughly and checked for compatibility. Any unstable or failing coatings must be removed before application. Porous plaster surfaces can also be sealed using a 10–15% thinned primer coat of Swimming Pool Paint.

Metal surfaces should be cleaned and degreased prior to coating. Prime all prepared metal areas using Teamac Metaclor Underwater Primer before applying Swimming Pool Paint.

Apply the coating evenly by brush or roller at the recommended spreading rate of approximately 14m² per litre. For best results, apply a minimum of three coats in total, allowing 24–48 hours between coats where possible. Avoid over-applying the product and do not paint in direct sunlight, damp conditions or when rain is expected.

After the final coat has been applied, leave the pool for a minimum of 14 days before filling with water to allow the coating system to fully cure.

Important:

• Leave the final coat for at least 14 days before filling pool with water
• Ensure good ventilation for indoor pools
• Do not apply in direct sunlight or damp conditions

If applying by roller, lay off with a brush to prevent trapped air bubbles.

FAQ's

Can this be used on newly built swimming pools?

Yes - but concrete must cure for at least 28 days and moisture content must be below 7%.

Can I apply this over existing swimming pool paint?

Yes, if the existing coating is a compatible chlorinated rubber system and remains soundly adhered.

How long before I can refill the pool?

A minimum of 14 days after the final coat is strongly recommended.

Is this paint chlorine resistant?

Yes - the coating is specifically designed for chemically treated swimming pool environments.

Can this be applied by roller?

Yes, although laying off with a brush is recommended for the best finish.

Is it suitable for fibreglass pools?

This product is primarily designed for concrete pools. Always contact technical support before application to alternative substrates.

Data Sheets

Coo-Var Swimming Pool Paint - TDS

Coo-Var Swimming Pool Paint Guidance