FuelTech FT600 Motorsport Wiring Loom

Motorsport-grade ETFE (MIL-W-22759/16) wiring loom engineered specifically for the FuelTech FT600 Engine Control Unit.

This wiring loom is designed for builders who require a reliable, professional-grade electrical foundation for a FuelTech FT600–controlled engine. Hand-built using MIL-W-22759/16 motorsport-grade ETFE wire, it is intended for high-performance and advanced motorsport applications where heat, vibration, electrical noise, and system density are part of the operating environment.

With its sealed, IP-rated enclosure, the FT600 is also well suited to off-road, marine, and watersports applications, where exposure to dust, moisture, and harsh operating conditions is unavoidable.

Whether you’re building a high-horsepower drag racing program, an off-road competition vehicle, a marine or watersports setup, or a no-compromise performance build, this loom removes the compromises commonly found in universal or automotive-grade wiring.

Designed Specifically for FuelTech FT600

This loom is pinned exclusively for the FuelTech FT600 ECU. Every circuit is allocated correctly for the ECU’s engine management inputs, outputs, power supply, and high-speed CAN communications — with no universal pinouts, repurposed circuits, or guesswork.

The result is a clean, predictable wiring system that supports accurate sensor data, stable ECU operation, and reliable integration with FuelTech power management, data logging, and CAN-based accessories.

Built Using Motorsport-Grade ETFE Wire (MIL-W-22759/16)

MIL-W-22759/16 ETFE wire was originally developed for aerospace and military applications and is ideally suited to harsh motorsport, off-road, and marine environments.

Key benefits include:

• Excellent resistance to heat, fuels, oils, and automotive chemicals

• Thin, lightweight insulation for compact, high-density looms

• High durability under vibration and continual movement

• Reduced risk of insulation degradation over time

This wire is selected for reliability — not cost.

Terminated or Unterminated Options

This FT600 loom is supplied in an unterminated (flying lead) configuration as standard, allowing complete flexibility for engine layout, sensor selection, power distribution, CAN integration, and routing.

A pin placement sheet showing wire numbers is available to download to assist with installation.

Custom terminations, wire lengths, multi-CAN provisions, and additional system integrations can be discussed prior to ordering if required.

Suitable Applications

This loom is suitable for:

• High-horsepower drag racing and roll racing

• Off-road and rally competition

• Marine and watersports applications

• Advanced street and competition vehicles

• Engine swaps and custom conversions

• Professional workshops and motorsport fabricators

This is not a vehicle-specific plug-and-play harness. It is intended for custom installations where control, reliability, and electrical integrity matter.

What’s Included

• FuelTech FT600 ECU connector(s)

• Pre-wired ETFE (MIL-W-22759/16) wiring loom

• Built to order and quality checked prior to dispatch

Sensors, actuators, PDMs, and the ECU are not included.

Lead Time

Each loom is hand-built to order. Typical lead time is displayed at checkout and may vary during busy periods.

If your build has a fixed deadline, please contact us prior to ordering.

Built to Support High-End and Harsh-Environment Builds

The FuelTech FT600 is a high-capability, sealed motorsport ECU designed for demanding applications. This loom is built to support it properly — without shortcuts, compromises, or unnecessary complexity — across motorsport, off-road, and marine environments.

Select options above or contact us to discuss custom requirements.

Legal Notice

FuelTech® is a registered trademark of FuelTech Ltd. This product is not affiliated with or endorsed by FuelTech.