Rust-Oleum EpoxyShield Maxx – Durable Water-Based Floor Coating for Heavy Traffic

Rust-Oleum EpoxyShield Maxx is a user-friendly, water-based epoxy floor coating designed for medium to heavy-duty traffic areas. With ultimate adhesion and durability, it delivers a long-lasting gloss finish, with optional non-skid or decorative effects, while resisting wear, impact, and abrasion from heavy foot and vehicle traffic.

Highly resistant to solvents, chemicals, and car tyres, EpoxyShield Maxx provides long-lasting protection for garages, workshops, and industrial floors. No primer is required, making application simple and efficient.

Key Features:

• Water-Based & User-Friendly – Easy to apply with no primer required
• For Medium to Heavy Traffic – Ideal for garages, workshops, and industrial floors
• Long-Lasting Gloss Finish – Optional non-skid or decorative effects
• High Chemical & Tyre Resistance – Withstands solvents, chemicals, and car tyres
• Impact & Abrasion Resistant – Durable under heavy foot and vehicle traffic

Surface Preparation

Repair any holes or cracks with EpoxyShield concrete repair products. If the floor is
previously painted, remove any loose paint by sanding and scraping. Remove oil and
grease using a scrub brush and EpoxyShield cleaner/degreaser. Rinse thoroughly with
fresh water afterwards. Remove all water and allow to dry completely. Wipe your fingers
over the clean, dry floor. If you see any dust or powder, repeat the rinsing until the floor is
clean. Wipe your fingers over the clean, dry floor. If you see any dust or powder on your
fingers, repeat the rinsing and scrubbing until the floor is clean.

Technical Data

Density (g/cm³): 1,27
Gloss Level: Satin
Solids content in volume: 63.6%
Mixing Ratio: Base : Activator = 3 : 1 (volume)

Directions for Use

Pour the contents of A into B and stir thoroughly for at least 3 minutes. Allow mixed product to stand (see table) before rolling the coating on to the surface. Do not leave container in direct sunlight. Mix again before applying. The product must be used within 1 to 2 hours of initial mixing (pot life, see table). This time decreases at higher temperatures. Do not mix Paint Chips with Epoxyshield® 5300 MAXX.

Apply when air (ambient) temperature is 15-35ºC and relative humidity is below 80%.
Concrete floors take a long time to warm up; make sure the previous day has also been at
least 15ºC prior to painting. Minimum floor temperature for painting is 13ºC. Painting in mid afternoon ensures the best cure.

After the full 60 minutes use a paint roller (20 cm) to apply an even coat of Epoxyshield®
5300 MAXX onto the surface. Apply in sections of 1,5 x 1,5 m so that Epoxyshield®
Decorative Chips can easily be scattered on the freshly coated surface. Maintain a wet
edge to prevent lap marks and gloss differences. Sprinkle the decorative paint chips onto
the wet film (note: this step may be skipped if chips are not desired. This will not affect the
performance of the coating). Immediately continue to coat the next section (note: fresh
paint can be applied over the loose chips that lay outside the previously painted area).

Data Sheets

Rust-Oleum EpoxyShield Maxx TDS

Rust-Oleum EpoxyShield Maxx Base MSDS

Rust-Oleum EpoxyShield Maxx Activator MSDS