Meet the Europa Tools Long Series Drill — a purpose-built metalworking companion that blends rugged strength with extended reach. Designed for serious drilling tasks, this 6 mm diameter drill reaches 260 mm in overall length, enabling deep-hole work in confined spaces without sacrificing rigidity or precision. Built with a powder metal core and a TiAlN-tipped edge, it delivers dependable performance when you need clean, accurate holes in demanding materials.

Key features that matter in real-world fabrication

• Long reach, compact versatility: The 260 mm overall length provides extended access for deep holes and recessed workpieces, reducing the need to re-clamp or rework.
• Powder metal body for toughness: Engineered to withstand demanding drilling tasks, offering improved shock resistance and durability over standard bits.
• TiAlN-coated cutting edge: The titanium aluminum nitride tipped edge enhances heat resistance and cutting efficiency, helping maintain sharpness and extend tool life even on harder metals.
• Precision geometry for clean results: Ground flute geometry promotes steady penetration, efficient chip evacuation, and reduced hole wandering for consistent hole quality.
• Material versatility for ferrous metals: Well-suited for steel, stainless steel, cast iron, and other tough alloys where reliable performance matters.

Why this drill makes a difference in your workshop

For fabricators, automotive technicians, and maintenance pros, the Europa Tools Long Series Drill is a practical choice when deep, straight holes are essential. Its combination of powder metal toughness and TiAlN coating translates to fewer tool changes, less downtime, and more precise results in thick materials or assemblies with tight tolerances. The long form factor isn’t about novelty — it’s about enabling you to tackle tasks that would otherwise require multiple steps or special setups.

Optimized use and care tips

• Lubrication and heat management: Use appropriate cutting fluid or coolant to manage heat and extend tool life on steel and tougher alloys.
• Speed and feed: Start with a conservative feed to seat the tip, then increase gradually to maintain a steady, controlled cut without overheating.
• Chip evacuation: Maintain clear chips to prevent clogging and heat buildup; pause to back off and clear if needed.
• Tool life preservation: Inspect the TiAlN edge for signs of wear and avoid sudden overloads that can chip the cutting corner.

Whether you’re drilling through thick plates, fabricating assemblies with deep pockets, or creating precise openings in challenging materials, the Europa Tools Long Series Drill in 6 mm x 260 mm delivers reliable performance, extended reach, and long-lasting precision.