Blackfriar Epoxy Floor Paint (Water-Based) – Heavy Duty, Low Odour Coating

Blackfriar Epoxy Floor Paint (Water-Based) is a two-pack, high-performance floor coating designed for heavy traffic areas. It offers exceptional durability and resistance to oil, chemicals, solvents, and abrasion, making it ideal for industrial, commercial, and workshop floors. The low-odour, water-based formulation ensures easy application and a professional finish.

Key Features:

• Two-pack, heavy-duty epoxy coating

• Exceptional resistance to oil, chemicals, and abrasion

• Designed for high-traffic environments

• Suitable for wood, metal, concrete, masonry, and asphalt

• Indoor use only

• Low odour and water-based

• Semi-Gloss Finish

Application Information:

• Coverage: 6 m²/L per coat

• Hard Dry: 12 hours at 20°C

• Recoatable: 12–72 hours

Surface Preparation

Ensure the surface to be painted is sound, clean, dry and free from grease or any substance liable to give adhesion problems. Scrape off any old or flaking paint until you have a firm surface. Special attention should be given to areas under cars to ensure all oil, grease, dirt and road salt is removed. New concrete must be left for at least 6 months
before applying Blackfriar Professional Water Based Epoxy Floor Paint. For previously painted areas ensure existing coatings are well adhered to the substrate and mechanically
abrade glossy surfaces.

Technical Data

• Water Based formulation, ideal for use in hospitals and food and drink environments.
• Resists grease, oil and weaksolutions of acid and alkali.
• Prevents the dusting of concrete surfaces.
• Indoor use.
• Brush or roller application.
• Can be applied over existing surfaces such as brickwork, concrete, cement, wood, metal and stone.

Coverage Rate - 6m2/litre per coat. Two coats recommended.

Drying Time
12hrs @20°C. Allow to dry for a minimum of 12hrs @20°C
and maximum 72hrs @20°C between coats. Full cure is
achieved in 5-7 days @20°C.

Directions for Use

Stir base thoroughly before adding all of the activator then mix well. DO NOT MIX PART UNITS. Allow to rest for 5 minutes before using. Pot life is 2 hours at 20°C. Apply with
a brush or roller working the paint in any surface imperfections. On bare or new surfaces first apply Blackfriar Professional Water Based Epoxy Floor Primer followed by 1-2 coats of Blackfriar Professional Water Based Epoxy Floor Paint. On previously painted surfaces apply 1-2 coats as required. Blackfriar Professional Water Based Epoxy Floor Paint is not suitable for use over PVC, thermoplastic tiles, quarry tiles, or granolithic concrete. Do not apply it on concrete surfaces treated with alkali containing liquids, areas subjected to rising damp or areas treated with PVA bonding solutions. Do not apply in cold (below 15°C), damp or humid conditions. If concrete floors are very smooth then pre-treat with Blackfriar Professional Acid Etch followed after thorough rinsing by Blackfriar Professional Water Based Epoxy Floor Primer prior to applying 1-2 coats of Blackfriar Professional Water Based Epoxy Floor Paint. Surfaces are slippery when wet. To ensure slip resistance
the floor must be kept dry when in use. The use of protective mats will help preserve the surface under tyres

Data Sheets

Blackfriar Epoxy Floor Paint Water Based TDS

Blackfriar Epoxy Floor Paint Water Based Part A MSDS

Blackfriar Epoxy Floor Paint Water Based Part B MSDS